Hyundai Blind Spot Detection System Not Working – What To Do

So you have just encountered a problem with the Hyundai blind spot detection system not working. What’s the next step?

If this is an issue you’re dealing with right now, it can be quite concerning. After all, you need this blind spot detection system to help you as you drive and avoid obstructions. You rely on the BSD to send you an alert when you are getting close to another vehicle, or any possible thing your car might bump against.

Thus, when it is not working right, a Hyundai BSD system reset or a way to know how to fix BSD system Hyundai vehicles require is essential. How is it done? Keep reading to learn more.

hyundai blind spot detection system not working

Hyundai Blind Spot Detection System Not Working

The first thing you need to do is to check BSD system Hyundai professional mechanics do to determine the cause of the issue.

If you have observed that it is malfunctioning, then it is possible that you will need to recode and then recalibrate the system to get it working once more.

How do you reset and recalibrate your Hyundai’s BSD? Here are some tips.

1. Use the detection tool.

Turn the ignition on and hook the tool up to detect the ID and VIN of your vehicle. Click on the scanner, which is located right in the BSD module. Work on the left side and place it on a system test called “Blind Spot Detection Calibration.” What this does is it sets your BSD radar once replacement is done.

2. Clearing Missing Calibration Components

Then, this process should be able to clear missing calibration issues and DTCs. Thus, radar sensors will be able to proceed to the self-alignment steps.

Afterwards, the sensors will self-align as you drive the vehicle. Be patient, as it takes about 30 seconds for the entire process to be over. Moreover, you can’t even cancel the process once you have initiated it, so just wait for it to be done.

3. Cycle the ignition.

Next step, you need to cycle your ignition after it turns off and on again. Wait for the process to be over then hit the “Continue” option. When coding is complete, that means one side is finished. The communication with your vehicle has been done, which is why you can move on to the right side.

4. Double check codes.

When you have performed the same procedure for the other side, be sure to double check for any codes. This way, you can be certain that nothing is wrong when you are driving. When you don’t notice any codes, it means that your BSD is already reset and calibrated. Then, it’s ready to go!

Read More: How To Do A Hyundai Emblem Replacement Like A Pro

Bottom Line

Resetting and recalibrating your Hyundai BSD takes some work but it is well worth the effort. Now that you know how to perform these steps, you can go ahead and make sure it is working well. Be sure to take the time to go through each step carefully, so you can achieve the result you want and stay safe on the road.

Leave a Comment