BSD Cancelled On Hyundai? Causes And What To Do

Do you have a BSD cancelled on Hyundai?

You rely on the BSD or the Blind Spot Detection feature of your vehicle for safety purposes. It helps when driving on a road where there is a blind spot, so you don’t find yourself in an accident.

However, there are cases when the BSD canceled notification may occur. 

For vehicles with this feature, the trailer tends to interfere with your BSD system. Hence, this results in a cancellation of your BSD functionality. This is why you may see a BSD cancelled alert on your instrument cluster.

The BSD cancelled message also stays on even if you disable the system manually. Hence, you may find yourself at a loss on what to do next.

Keep reading to find out how to deal with this issue and some common fixes you can look into.

bsd cancelled on hyundai

BSD Cancelled On Hyundai

So you have found yourself in a serious dilemma with the BSD cancelled on your Hyundai. Now, you may be wondering what it is you can do to fix it. 

First of all, if you come across this problem, there are certain things that you can do to address it accordingly. For instance, get it checked by a professional mechanic and have it diagnosed appropriately.

You may even be able to recode and recalibrate your BSD system, so it can get to work as it should. 

Now, the next question is how to reset and recalibrate. There are a few things you can do. 

1. Detection tool

First, turn your ignition on and hook your detection tool up. This should be able to detect your VIN and ID of your car. Click the scanner on that is found in your BSD module. Work on your left side and then place it on a Blind Spot Detection Calibration system test. This should set the BSD radar after going through the replacement process.

2. Clear any missing calibration issues

Afterwards, you need to clear missing DTCs and calibration issues. By doing so, the radar sensors can perform the self-alignment process. Moreover, the sensors will be able to self-align while you drive your vehicle. You need to be patient as this can take up to 30 seconds to finish. 

It is also important to note that you will not be able to cancel this process when you have already initiated it. Hence, the only thing to do is to wait for it to be over.

3. Cycle your ignition.

Once you have cleared any missing calibration issues, you now have to cycle the ignition. Do this after it goes into an off and on status. Again, you should be patient and wait for this process to finish. Next, select the “Continue” option to proceed.

After completing the coding, it means one portion is finished with the process. You can then proceed to the next side of your vehicle.

4. Check codes once more.

It is important that you double-check any codes after performing the procedure on both sides of your vehicle. This is a very essential process not to be missed since you want to be completely sure that there is nothing  faulty or erroneous as you drive.

If you do not see any codes showing up, this means that you have successfully reset and calibrated your BSD system. And with that being said, it should be good to go without any problems at all.

Read More: Hyundai Blind Spot Detection System Not Working – What To Do

Wrapping Up

There may be an instance when a BSD cancelled on Hyundai may appear. When this happens, it can be quite concerning since you rely on this system for safety purposes.

However, no need to fret – you can simply reset and recalibrate the BSD system to get it to work as it should. If the issue is not serious, and there is no need to take your vehicle to a professional mechanic, you can simply perform the steps we have shared with you when it comes to the resetting and recalibrating process.

Then, you should be able to get back on the road safely and with peace of mind, knowing that your BSD system is functioning as it should once more.

Leave a Comment